Logs

Country
Iran, Islamic Republic of (IR)
Group
Logs
End use
Processing
NPPO Details
Plant Protection Organization
Relevant Web Addresses
http://www.ppo.ir/
Criteria Criteria Required?
Import Permit No
Phytosanitary Certificate Yes
Additional Declaration/Endorsement Yes
Protocol Market No
Consignments are to be free from pests, soil, weed seeds and extraneous material.


These import conditions are applicable to the following species of Coniferous Logs Without Bark:
  • Pinus spp
  • Cupressus spp
  • Abies spp
  • Picea spp
  • Juniperus spp
  • Cedrus spp
Logs must be completely free from bark and holes due to wood boring insects infestation.
These import conditions are applicable to Coniferous Logs without Bark as listed above only.

NOTE: 
  • These conditions are not applicable to Logs of Fagus spp.
    Contact Grain and Seed Exports Program (Grain.Export@agriculture.gov.au) for visible signs of Blue stain (Ophiostoma spp), Foot rot (Phytophthora spp) and Damping off (Calonectria spp) on logs.
The Export Control Act 2020 and the Export Control (Wood and Woodchips) Rules 2021, require an export licence issued by the Department of Agriculture, Fisheries and Forestry for any exports of two tonnes or more of:

  • woodchips;
  • wood in the round (i.e. logs);
  • wood with a cross-sectional area of at least 225 square centimetres

These are considered 'prescribed goods' under the Export Control (Wood and Woodchips) Rules 2021. 

A licence is not required for the above listed wood and woodchips if:
  • the wood or woodchips are sourced from an area covered by a Regional Forest Agreement (RFA). Details regarding the areas covered by RFAs can be found here: https://www.agriculture.gov.au/forestry/policies/rfa.
  • the wood or woodchips are derived from trees harvested outside Australian territory, including those transiting through Australia.
  • the wood or woodchips are sourced from a plantation in a State with an approved code of practice for the establishment, management and harvesting of all plantations in that State.

If an export licence is required, it is the responsibility of exporters to obtain a licence to export prescribed wood or woodchips prior to export.

Exporters can find information on how to obtain an export licence for prescribed wood or woodchips on the departments website - Exports of unprocessed wood and woodchips (wood export licensing) - DAFF.

Any enquires on what is classed as prescribed wood or woodchips should be directed to: wood.export@aff.gov.au, or call (02) 6272 4353.

The only responsibility authorised officers have in relation to the export licences for unprocessed wood is to inform unprocessed wood exporters of the possible requirement to hold a licence to export unprocessed wood.

Consignments are to be treated with one of the following:
 
Methyl bromide at:
  • 48 grm/m3 for 24 hours at 21 degree Celsius or above
OR
  • 56 grm/m3 for 24 hours at 15-20 degree Celsius or above
OR
  • 64 grm/m3 for 24 hours at 10-15 degree Celsius or above
OR
 
Heat Treatment at:
  • 70 degree Celsius core temperature maintained for a minimum of four hours (Signed temperature log sheet must be attached with the phytosanitary certificate)
OR

Kiln Drying at:
  • Raising core temperature to 74 degree Celsius as follows:
Time, hours468101418> 18
Thickness, mm0-1526-5051-7576-100101-150150-200> 200
Moisture contents must be less than 14%. Moisture contents may be checked on arrival.

The exporter is to provide evidence attesting to the treatment and present it to the Authorised Officer at the time of inspection.


Details of treatment to be endorsed on the phytosanitary certificate in the treatment section.


Fumigation of logs in bulk vessel holds

Note: Fumigators may use the Minor Use Permit for methyl bromide obtained by the Department of Agriculture, Fisheries and Forestry to meet the importing countries phytosanitary import requirements.

  • Fumigation must be done at the methyl bromide schedule listed above.
  • Prior to commencement of fumigation, an in-hold fumigation plan must be approved by the Grain and Seed Exports Program. The fumigator/exporter is to provide the Grain and Seed Export Program (Grain.Export@agriculture.gov.au) with:
    • Vessel name and IMO, as well as the hold number(s) being used to fumigate logs
    • A draft certificate containing the dosage, temperature and duration in accordance with treatment requirements in Micor/import permit, as well as the vessel name, RFP(s), holds loaded, commodity and its quantity, and signature by a registered fumigator with their contact details.
    • Method of clearing the fumigant from the hold and providing gas-free certification
    • Method of sealing holds during fumigation
    • The re-circulation method and locations of delivery and monitoring lines
  • A reinspection of the logs after fumigation must be done as per the instructional material requirements.

Option 1 (EXDOC Endorsement 5603)
1) Sawyer beetle (Monochamus spp), Pine weevil (Pisodes spp), Pine shoot beetle (Tomicus spp), European larch canker (Lanchnellula willkommii), Pinch canker (Fusarium circinatum), Pinewood nematodes (Bursaphelenchus xylophylus and Bursaphelenchus mueronatus), Spruce beetle (Dendroctonus spp) and Scleroderris canker disease (Gremmeniella abietina) are not known to occur in Australia,
2) A representative sample was inspected and found to be free of Sirex wasp (Sirex spp), Bark beetle (Ips spp), Blue stain (Ophiostoma spp), Ambrosia beetle (Platypus spp), Foot rot (Phytophthora spp) and Damping off (Calonectria spp).
NPPO Notification No 730/9481 dated 7 July 2016.
31/01/2025 - Updated general requirements due to legislation changes.
26/07/2023 - Updated treatment requirements to specify that in-transit fumigation is subject to approval of in-hold fumigation plan by GSEP for each fumigation event.
10/11/2021 - Updated general requirements due to legislation changes.
Initial Uploaded: 20/09/2018
Reviewed Uploaded: 18/07/2026